What will be the TCCR0 value for Normal Mode, no prescalar, with the clock coming from the AVR Crystal.
Question
What will be the TCCR0 value for Normal Mode, no prescalar, with the clock coming from the AVR Crystal.
Solution
To set the TCCR0 for Normal Mode, no prescalar, with the clock coming from the AVR Crystal, you would need to set the bits as follows:
-
First, you need to set the WGM00 and WGM01 bits to 0 for Normal mode. This is done by ANDing the TCCR0 register with the binary number 11111100. This will ensure that the first two bits are 0, regardless of their initial state.
-
Next, you need to set the CS00 bit to 1 and the CS01 and CS02 bits to 0 for no prescaling. This is done by ORing the TCCR0 register with the binary number 00000001. This will ensure that the last bit is 1 and the two before it are 0, regardless of their initial state.
So, the TCCR0 value for Normal Mode, no prescalar, with the clock coming from the AVR Crystal would be 00000001 in binary or 0x01 in hexadecimal.
Similar Questions
f the crystal frequency is 4.5 MHz, determine the time for setting the timer flag for mode 1 if TH0 starts at 00H.1 point12 ms2 ms174.78 ms50 ms
Assume that XTAL= 8MHz. Find the TCNT0 value needed to generate a time delay of 5ms. Use Normal Mode, and the largest prescaler possible.
In AVR microcontroller, the machine cycle is of 1 clock period of crystal frequency.Group of answer choicesTrueFalse
In low-power run mode the clock frequency is reduced below:*2 MHz80 MHz26 MHz8 MHz
If a Crystal of 4 MHz is connected to X1 and X2 pins of 8085, what will be frequency at Clk Out
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.