Knowee
Questions
Features
Study Tools

Drag the commands required to give the switch the hostname of SW1.blank blank blank hostname SW1Configure terminalend

Question

Drag the commands required to give the switch the hostname of SW1.

blank
blank
blank
hostname SW1
Configure terminal
end

🧐 Not the exact question you are looking for?Go ask a question

Solution

To set the hostname of the switch to "SW1," you would typically enter the following commands in sequence in the command-line interface (CLI) of the switch. The commands are:

  1. configure terminal - This command puts you into global configuration mode.
  2. hostname SW1 - This command sets the hostname of the device to SW1.
  3. end - This command exits from global configuration mode back to the privileged EXEC mode.

Final Commands Sequence

configure terminal
hostname SW1
end

So the required sequence of commands would be:

  • configure terminal
  • hostname SW1
  • end

This problem has been solved

Similar Questions

Which of the following command is used to show the host name?Select the correct optionReload Math Equations IPhost Ipconfig IPcon /all Ipconfig /all

What PowerShell cmdlet will show us the IP configurations of the hosts network adapters.

Which mode configuration setting would allow formation of an EtherChannel link between switches SW1 and SW2 without sending negotiation traffic?

This command "switchport mode access" is configured on the routerSelect one:TrueFalse

The command "vlan 10" ten will create a vlan 10 on a switchSelect one:TrueFalse

1/1

Upgrade your grade with Knowee

Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.