To apply a Control Plane Policing (CPPr) policy to a host subinterface in Cisco IOS, you would typically use the following command:

```plaintext
service-policy input [policy-map-name]
```

This command should be entered in the interface configuration mode, where `[policy-map-name]` represents the name of your previously defined policy map that contains the CPPr policy.

Make sure you replace `[policy-map-name]` with the actual name of the policy map you want to apply. Here’s the general step to do it:

1. Enter the interface configuration mode for the desired subinterface:
```plaintext
interface [subinterface-name]
```

2. Apply the service policy:
```plaintext
service-policy input [policy-map-name]
```

This setup will ensure that the CPPr policy is appropriately applied to the incoming traffic on the specified subinterface.

Question

To apply a Control Plane Policing (CPPr) policy to a host subinterface in Cisco IOS, you would typically use the following command:

```plaintext
service-policy input [policy-map-name]
```

This command should be entered in the interface configuration mode, where `[policy-map-name]` represents the name of your previously defined policy map that contains the CPPr policy.

Make sure you replace `[policy-map-name]` with the actual name of the policy map you want to apply. Here’s the general step to do it:

1. Enter the interface configuration mode for the desired subinterface:
   ```plaintext
   interface [subinterface-name]
   ```

2. Apply the service policy:
   ```plaintext
   service-policy input [policy-map-name]
   ```

This setup will ensure that the CPPr policy is appropriately applied to the incoming traffic on the specified subinterface.

Knowee AI · Accepted Answer

To apply a Control Plane Policing (CPPr) policy to a host subinterface in Cisco IOS, you would typically use the following command:

```plaintext
service-policy input [policy-map-name]
```

This command should be entered in the interface configuration mode, where `[policy-map-name]` represents the name of your previously defined policy map that contains the CPPr policy.

Make sure you replace `[policy-map-name]` with the actual name of the policy map you want to apply. Here’s the general step to do it:

1. Enter the interface configuration mode for the desired subinterface:
   ```plaintext
   interface [subinterface-name]
   ```

2. Apply the service policy:
   ```plaintext
   service-policy input [policy-map-name]
   ```

This setup will ensure that the CPPr policy is appropriately applied to the incoming traffic on the specified subinterface.

Which Cisco IOS command applies the CPPr policy to the host subinterface?policy-mapclass-mapservice-policypolice

Question

Which Cisco IOS command applies the CPPr policy to the host subinterface?

Solution

Similar Questions

Upgrade your grade with Knowee