What is the command to configure static routing through CLI ?1 pointip route destination_network [subnet_mask] IP_address_of_next_hop_neighbor show ip route
Question
Solution 1
The command to configure static routing through Command Line Interface (CLI) is as follows:
- Enter the global configuration mode by typing
configure terminal
orconf t
and press Enter. - To configure a static route, use the
ip route
command followed by the destination network, subnet mask, Knowee AI StudyGPT is a powerful AI-powered study tool designed to help you to solve study prob
Knowee AI StudyGPT is a powerful AI-powered study tool designed to help you to solve study problem.
Knowee AI StudyGPT is a powerful AI-powered study tool designed to help you to solve study problem.
Knowee AI StudyGPT is a powerful AI-powered study tool designed to help you to solve study problem.
Knowee AI StudyGPT is a powerful AI-powered study tool designed to help you to solv
Similar Questions
What is the command to configure static routing through CLI ?1 pointip route destination_network [subnet_mask] IP_address_of_next_hop_neighbor show ip route
Why did we use the show ip route command ?1 pointTo configure static routingTo display the current state of the routing table.
The CLI prompt is Router1(config-if)#. Which operation is the administrator likely to configure next?
What command produced this output?Question 1Select one:ipconfigifconfigip route showiip addr show
What must be specified when configuring a static route for a point-to-point interface A. The next hop B. The mask C. The outbound interface D. The IP address