What must be specified when configuring a static route for a point-to-point interface A. The next hop B. The mask C. The outbound interface D. The IP address
Question
What must be specified when configuring a static route for a point-to-point interface?
A. The next hop
B. The mask
C. The outbound interface
D. The IP address
Solution
When configuring a static route for a point-to-point interface, the following must be specified:
A. The Next Hop: This is the IP address of the next hop or the next device that will be used to reach the destination network.
B. The Mask: This is the subnet mask that is associated with the IP address. It is used to identify the network and host portions of the IP address.
C. The Outbound Interface: This is the interface on the router that will be used to send out the packets to the destination network.
D. The IP Address: This is the IP address of the destination network that the static route is being configured for.
Similar Questions
What is the command to configure static routing through CLI ?1 pointip route destination_network [subnet_mask] IP_address_of_next_hop_neighbor show ip route
When configuring a static route on FortiGate, what does the destination represent?
hat type of route is created when a network administrator manually configures a route that has an active exit interface?staticdynamiclocaldirectly connected
What type of route is indicated by the code C in an IPv4 routing table on a Cisco router?
What concept in routing uses sub interfaces?Question 10Select one:ROASTPOSTROAS
Upgrade your grade with Knowee
Get personalized homework help. Review tough concepts in more detail, or go deeper into your topic by exploring other relevant questions.