Which command will show you the STP root bridge for a VLAN?Question 2Select one:show spanning-treeshow ip routeshow ip interface brief

Question

Which command will show you the STP root bridge for a VLAN?Question 2Select one:show spanning-treeshow ip routeshow ip interface brief
🧐 Not the exact question you are looking for?Go ask a question

Solution 1

The command that will show you the STP (Spanning Tree Protocol) root bridge for a VLAN (Virtual Local Area Network) is "show spanning-tree". This command displays STP information for a switch or bridge.

Here are the steps to use this command:

  1. Open the command line interface on your switch or r Knowee AI StudyGPT is a powerful AI-powered study tool designed to help you to solve study prob
Knowee AI StudyGPT is a powerful AI-powered study tool designed to help you to solve study problem.
Knowee AI StudyGPT is a powerful AI-powered study tool designed to help you to solve study problem.
Knowee AI StudyGPT is a powerful AI-powered study tool designed to help you to solve study problem.
Knowee AI StudyGPT is a powerful AI-powered study tool designed to help you to solv

This problem has been solved

Similar Questions

Which command will show you the STP root bridge for a VLAN?Question 2Select one:show spanning-treeshow ip routeshow ip interface brief

The command "vlan 10" ten will create a vlan 10 on a switchSelect one:TrueFalse

Which of the following options can be used with the ifconfig command to set the IP address of an interface?Select one:a.-inetb.-addressc.-ipd.-set

Why did we use the show ip route command ?1 pointTo configure static routingTo display the current state of the routing table.

What is the command to configure static routing through CLI ?1 pointip route destination_network [subnet_mask] IP_address_of_next_hop_neighbor show ip route

1/2